MTM Hydro's Replacement Filter Kit for the Professional Foam Cannon 14.5012, 14.0263, and 14.0349 includes:
4 - O-Rings.
1 - Compressed Stainless Steel Filter
This kit fits the pictured model shown below as well as the low volume bayonet version:
MTM Hydro's Stainless Steel Foam Cannon Filter is a replaceable maintenance item that fits all MTM Foam Cannons of the Original Series. The filter is a woven Italian Stainless mesh that operates as an agitator when the chemical and pressurized stream hits it. To the naked eye, it looks similar to the cheap Chinese versions but once it is disassembled, there is a distinct pattern developed by our Italian engineers that ensures a thicker clinging foam.
From the models we have tested, this Filter will fit in competing foam cannons in addition to MTM Hydro's. Don't expect the same results though, the MTM Hydro Stainless orifice, and sequential conical chambers of our Cannons have equal importance to the foam output.
As an agitator, this item will get clogged over time and if you use waxes, the sticky compounds are notorious for causing a faster failure rate. If you suspect a clog, and you remove the agitator, there will be no noticeable issue as the sticky chemical compounds are driven deep into the middle which creates additional back-pressure and inhibits foam creation.
FAQ: "How do I know my filter/agitator should be replaced?"
ANSWER #1: If it used to foam well and it doesn't now, 99% of the time it is because the filter is clogged.
ANSWER #2: Some foam is coming out but the stream is very weak and you notice foam coming out other places due to back pressure.
This produt can expose you to chemicals, including DINP and/or DEHP which is know to the state of California to cause cancer or birth defects or other reproductive harm, go to www.p65Warnings.ca.gov for more information.
The products we sell are not intended for use in potable water systems and are only for industrial non-drinking water applications.