MTM Hydro's complete Industrial Sand Blast Kit provides maximum cleaning power with dustless sandblasting capabilities. Similar to the MTM Foam Cannons, these Sandblast kits use the venturi effect to draw sand through a hose where it is expelled at high speed against the cleaning surface with pressurized water. Sandblast kits are impressive cleaning devices as long as your orifice is correct and your draw hose stays dry.

*Note* this version of the MTM sandblast kit comes with two threaded nozzles and a 1/4" Male plug for quick installation. Be sure to use the correct sized nozzle for your machine as this will greatly impact the performance of the Industrial Sandblast kit.

Included Items in Complete sandblast kit:

Industrial sandblast kit w/ head, probe, and hose

1 - threaded 0° 4.0 nozzle

1 - threaded 0° 5.0 nozzle

1 - 1/4" plated steel Male plug to install at blast head inlet

1 - roll of teflon tape for installation

Specs Requirements:

Requires 3-8 GPM Pressure Washer

Requires 3,000-5,000 PSI Pressure Washer

Nozzle must be 0° Threaded nozzle fitting the specs of your machine

Tips:

Use the right sized nozzle!

Make sure your blast media is dry

Keep your draw line (hose) interior dry

Orient the sand barb (hose) to the top of the blast head so the sand drops into the chamber with the help of gravity, this will also limit the amount of water that could run down the hose if it was at the bottom.

Once you start cleaning limit the starting and stopping as this will create valleys of settled blast media in the draw hose and create an inconsistent flow of sand when you re-start.

PROP 65

WARNING

This product can expose you to chemicals, including DINP and/or DEHP which is know to the state of California to cause cancer or birth defects or other reproductive harm, go to www.p65Warnings.ca.gov for more information.

The products we sell are not intended for use in potable water systems and are only for industrial non-drinking water applications.

$17.00 $32.00

Pulse Hose Assembly

$17.00
$32.00